FSAirlines

Hi,

I have tried this same flight three times now. All three times the same thing has happened:

At 80kts, the number2 engine fails, so I stop the airplane, taxi off the active, and return to the stand. I then put the aircraft into a 'cold and dark' state and exit FS9. However, the client does not record any of this and simply puts the flight back to a booked state. It happens every time. I'm using the latest client. What am I doing wrong? Or is this a bug?

Thanks for any help

Its most likley just a bug. Ive never experienced this though

Hi Dave,

I think the only way round this is to taxi back in.
Exit the FlyNET client.
Exit FS9.
Cancel the flight from the Flynet Web control Panel ( It'll cost you )
Then re-book the flight.
Start again as per normal.
If it happens again ask Konny for a refund !

HTH

Rob

Well, you can't end a flight if you never were airborne
And are you sure the reason for your engine failure is the client ? I ask that because no failures are engaged on the ground and it's very very unlikely that a failure occurs during take off three times in a row.