Client won't record flight

Please report Bugs and Problems here

Moderator: FSAirlines Staff

Locked
dgor
Flight Attendant
Posts: 159
Joined: Thu May 04, 2006 9:37 pm
Location: Belfast, Ireland

Client won't record flight

Post by dgor » Sat May 13, 2006 6:53 pm

Hi,

I have tried this same flight three times now. All three times the same thing has happened:

At 80kts, the number2 engine fails, so I stop the airplane, taxi off the active, and return to the stand. I then put the aircraft into a 'cold and dark' state and exit FS9. However, the client does not record any of this and simply puts the flight back to a booked state. It happens every time. I'm using the latest client. What am I doing wrong? Or is this a bug?

Thanks for any help :)
Regards,
Dave

Image

ben_davies247

Post by ben_davies247 » Sat May 13, 2006 6:59 pm

Its most likley just a bug. Ive never experienced this though

UKD192

Post by UKD192 » Sat May 13, 2006 7:47 pm

Hi Dave,

I think the only way round this is to taxi back in.
Exit the FlyNET client.
Exit FS9.
Cancel the flight from the Flynet Web control Panel ( It'll cost you :P )
Then re-book the flight.
Start again as per normal.
If it happens again ask Konny for a refund ! :)

HTH

Rob

Konny
FSAirlines Developer
Posts: 1564
Joined: Sun Sep 25, 2005 10:40 am
Location: Munich, Germany
Contact:

Post by Konny » Sat May 13, 2006 8:28 pm

Well, you can't end a flight if you never were airborne ;-)
And are you sure the reason for your engine failure is the client ? I ask that because no failures are engaged on the ground and it's very very unlikely that a failure occurs during take off three times in a row.
Konrad - FSAirlines Developer
Image

Locked