FSAirlines

WILCO A321 LND Lights Problems

I am nos a 100% sure but since I had modified the aircraft.cfg and the panel.cfg, adding the A2A Simulations 3D LIGHTS REDUX, the application does not recognize that my LND lights are on at takeoff.

You can find or see the configurations here,
http://a2asimulations.com/forum/viewtop ... 32&t=11554



Thanks in advance

Geia,
I am not using Wilco but I think your problem (I am not sure) is the A2A gauge.
By using that, as soon as you retract the landing gear your landing lights go off.
My suggestion is not using that gauge and assigning 2 seperate key combinations,one for langing lights and one for the taxi lights (in fact they are nose wheel lights).
Edit your aircraft.cfg accordingly so that the nose wheel lights are recognized as taxi lights (so they should be 6 not 5). Then when entering in the active runway you can turn taxi lights off leaving only the landing lights on.
In the forum page that you have sent anyway, they seem like correct. Thus, your 2 lights are assigned as landing lights (lights 9 and 10 have 5) and one is assigned as taxi (light 11 has 6). So I think, the gauge is causing the problem, it turns all the lights off when you retract the gear.
Hope that helps.
Cheers,
Arslan

Good day

Yes you are right.
I found it also at their forum. I'll try it.

Thank you

Ok

works fine.


Regards

Good to hear.
Blue skies

Good day

Well I have again the same problem, same occurs with the previous client v1.1.3 and I had restore default light settings at aircraft.cfg.

Anyone using the latest client v1.1.4 with A2A Simulations 3D LIGHTS REDUX and has no problems or he has solve it, with Wilco AIRBUS. of course.

Thanks in advance